![background image](http://html1.mh-extra.com/html/ics/g135l/g135l_installation-instructions-and-user-manual_3542071006.webp)
6
ELECTRONIC DIGITAL CONTROLLER
UNDERSTANDING THE ELECTRONIC DIGITAL CONTROLLER
The cabinet is fitted with an electronic digital controller. The electronic digital controller operation diagrams
below explain the primary functions of the cabinet.
Refer to the
key
at the bottom of this page for more
information.
If you need to adjust the temperatures, please contact the
ICS PACIFIC
Service Department on (Toll Free)
1800 630 360
for assistance.
To operate the light
1.
To switch the light on or off press the UP / Light Button.
Reading and Resetting the High/Low temperature readings
1. To read the
highest temperature
the fridge has reached press the HI/LO Button once. The high
temperature will flash on the display.
2. To read the
lowest temperature
the fridge has reached press the HI/LO Button again within
10
seconds
of checking the high temperature. The low temperature will now flash on the display.
3.
To
clear and reset these values
press the HI/LO Button and hold it in for 6 to 7 seconds. The reset will
be signalled by one long beep.
4.
Every time the high and low temperatures are checked it is
important to clear and reset the
displayed values.
Alarm function
1. The alarm will activate if the temperature inside the fridge goes below 2ºC or rises above 8ºC for longer
than 30 minutes. The alarm will activate and the display will flash.
2. To mute the alarm, press the DOWN button. See “Special points to note” Point 15.0. The display will
continue to flash until the fridge returns to its normal operating temperature range of b2ºC to
+8ºC.
3. Trouble shooting - in the event of the alarm activating check:
-
The door is properly closed.
-
The fridge has adequate ventilation – Refer “Special points to note” Point 10.0
-
The fridge is stocked correctly - Refer “Set Up” (Page 4).
4. If the alarm is still activated after checking all the above contact the
ICS PACIFIC
service department.
Set Button
1. The SET button is for technician use only. Contact
ICS PACIFIC
for more information.
2. Do not press
or
hold down the SET button as by doing this you may detrimentally affect the
temperatures within the cabinet.