background image

 

SAFETY INSTRUCTIONS 

 

SAFETY INSTRUCTIONS 

 

Because these warnings are designed to help prevent serious injury to users or other 

persons and / or cause damage to the cabinets, please follow all instructions carefully. 

 

This manual contains important safety messages 

Lack of maintenance and / or misuse of the cabinet will void the Warranty 

 

  Do not insert the 3-pin power plug into the power point with wet hands. 

 

  Do not bend the power cord or place heavy items on it. If the power cord is damaged, 

arrange to have it replaced by a qualified electrical contractor. 
 

  Never connect the cabinet into a power point if the power cord has been damaged. 

 

  Do not disconnect the cabinet by pulling on the electrical cord. Always turn the cabinet off at 

the power point first and remove the 3-pin plug carefully from the power point. 
 

  Always disconnect the 3-pin plug of the cabinet from the power point before cleaning to 

avoid danger of electrocution. 
 

  Do not store volatile or flammable substances inside of the cabinet.  

 

  Do not place any pressurised containers into the cabinet. There is risk of explosion or fire. 

 

  Do not climb on or inside of the cabinet as this could result in serious injury. 

 

  Do not install the cabinet in a damp or wet location.  

 

  Do not make any alterations, repair or adhere anything to the cabinet by yourself. By doing 

so you will void the Warranty, cause malfunctions to the cabinet and / personal injury. 
 

  The cabinet is not intended for use by children or infirm persons without adult supervision. 

 

  Children should be supervised when near the cabinet. 

 

  The cabinet must be plugged into its own dedicated 220-240 Volt, 50Hz AC power point. 

 

 

Summary of Contents for G135L









Reviews: