Chapter 3: Hardware Configuation and Installation
Manual Number: 00650-014-4
Page 3-7
Calibration Procedure
The following procedure is brief and is intended for use in conjunction with the calibration part of
the SETA12 program.
1. Start the calibration program by typing SETA12 and press the ENTER key at the DOS prompt.
2. Use the relevant menu selections to set the switches and jumpers for the manner in which the
card will be calibrated; i.e., number of channels, and ±5V range). These settings are used by
the calibration portion of the program.
3. Use the arrow key to select option
7.Calibrate A/D,
then press the
ENTER
key.
4. Use the arrow key to select option
1.Adjust Offset
, from the
Action Menu
at the top left hand
corner of the screen.
5. Following the instructions on the screen, perform the offset adjustment
6. Use the arrow key to select option
2.Adjust Gain
, from the
Action Menu.
7. Following the instructions on the screen, perform the gain adjustment
8. Use the arrow key to select option
3.Check
, from the
Action Menu
.
9. Following the instructions on the screen, perform the calibration check.
10. This completes the calibration procedure.
