75
[
↑
] Up [
↓
] Down [ESC] Exit [Enter] Select
9. Highlight the array whose Status is “Critical”.
10. Press [Enter]. The following screen will then appear (see next page).
FastBuild (tm) Utility 1.xx (c) 1995-2000 Promise Technology, Inc.
[ Rebuild Array Menu ]
Array No RAID Mode Total Drv Status
Array 2 Mirror 2 Critical
Stripe Block: Not Available
[ Select Drive for Rebuild ]
Channel:ID Drive Model Capacity (MB)
1 : Slave QUANTUMCR8.4A 8063
[ Keys Available ]
[
↑
] Up [
↓
] Down [ESC] Exit [Enter] Select
11. Under [Select Drive for Rebuild], highlight the replacement drive.
12. Press [Enter] and confirm that the data will be copied on to the
selected drive. All data on the replacement drive will be written over
with mirrored information from the array drive. A progress bar will
appear as below.
Please Wait While Duplicating The Image
10% Complete
13. Once the rebuild process is complete, the user will be asked to
reboot the system.
76
Viewing Controller Settings
The Controller Configuration <6> menu selection allows you to enable
or disable the FastTrak100 BIOS from halting (the default) if it detects an
error on boot up. You may also view the system resources (Interrupt and
I/O port address) of FastTrak’s data channels.
FastBuild (tm) Utility 1.xx (c) 1995-2000 Promise Technology, Inc.
[ Adapter Configuration - Options ]
Halt On Error: Enable
[ System Resources Configuration ]
Channel 1 (IDE1) Interrupt : A I/O Port : FFF0
Channel 2 (IDE2) Interrupt : A I/O Port : FFA8
[ Keys Available ]
[
←
,
→
, Space] Change Option [ESC] Exit
Halting FastTrak BIOS On Bootup Errors
The [Adapter Configuration – Options] section allows you to enable or
disable FastTrak100 to Halt operation at the BIOS startup screen should
an error be detected. This is the only option that can be changed on this
screen.
Viewing FastTrak System Resources
The [System Resources Configuration] section of this submenu displays
the PCI slot interrupt and port address used by the FastTrak100. The
resources used are determined by the Mainboard PCI PnP BIOS for the
PCI slot in which the FastTrak100 resides.
In the rare case that there is a resource conflict, refer to the Mainboard
BIOS documentation on changes on resources allocated to the
FastTrak100 PCI slot.
