41
Appendix D. How to use Wake-Up Function
The ROCKY-3703EVR provides two kind of Wake up Function.
This page describes how to use Modem Wake-Up and LAN Wake-Up
function.
Wake-Up function is working while you use ATX power supply,
Wake-Up By Ring
:
You must set the option
Power On By Ring
of CMOS SETUP to be
enabled. The ATX power supply will be switched on when there is a ring
signal detected on pin “RI” of serial port.
Wake-Up On LAN
:
When your computer is in power-down status, you can see LAN
Link/Active LED is flashing. This status indicates that the LAN chip has
entered standby mode and waits for Wake-Up signal. You can use other
computers to wake up your computer by sending ID to it.
ID: ID is the address of your system LAN. Every LAN chip has a factory-
set ID, which you can find it from network information in WINDOWS.
ID’s format is xxxxxxxxxxxx
Example ID
: 009027388320
42
Appendix E. RAID FastTrak100
1. Introduction
Promise designed its FastTrak100 to provide a cost-effective, high
performance RAID that adds performance and/or reliability to PC
desktops and/or servers using Ultra ATA/100, Ultra ATA/66, or EIDE
drives.
FastTrak100 supports striping (RAID 0), mirroring (RAID 1),
striping/mirroring (RAID 0+1), or spanning (JBOD) operation,
respectively.
With striping, identical drives can read and write data in parallel to
increase performance. Mirroring increases read performance through
load balancing and elevator sorting while creating a complete backup of
your files. Striping with mirroring offers both high read/write performance
and error tolerance. Spanning uses the full capacity of all attached
drives without requiring identical drive size, but offers no other RAID
functionality.
A FastTrak100 striped array can double the sustained data transfer rate
of Ultra ATA/66 drives. FastTrak100 fully supports Ultra ATA/100
specification of up to 100 MB/sec per drive, depending on individual
drive specifications.
FastTrak100 also offers fault tolerant, data redundancy for entry-level
network file servers or simply for desktop PC users wanting to
continually protect valuable data on their PC. FastTrak100 offers RAID 1
mirroring (for two drives) and RAID 0+1 mirroring and striping (for four
drives) to protect data. Should a drive that is part of a mirrored array fail,
FastTrak100 uses the mirrored drive (which contains identical data) to
assume all data handling. When a new replacement drive is later
installed, FastTrak100 rebuilds data to the new drive from the mirrored
drive to restore fault tolerance.
