ICP Electronics JUKI-6752, Manual

Page: 10 / 21

15
3.7 LAN RJ45 Connector (CN9)
The JUKI-6752 built-in RJ45 LAN connector is for 10/100Mbps
Ethernet (82559ER).
•
CN9: LAN RJ45 Connector
1 TX+ 5 NC
2 TX- 6 RX-
3 RX+ 7 NC
4 NC 8 NC
3.8 Serial Ports(CN10,CN11)
The JUKI-6752 offers two high speed NS16C550 compatible UARTs
with Read/Receive 16 byte FIFO serial ports.
• CN10 : Serial Port DB-9 Connector( COM1)
PIN NO. DESCRIPTION
1 DATA CARRIER DETECT (DCD)
2 RECEIVE DATA (RXD)
3 TRANSMIT DATA (TXD)
4 DATA TERMINAL READY (DTR)
5 GROUND (GND)
6 DATA SET READY (DSR)
7 REQUEST TO SEND (RTS)
8 CLEAR TO SEND (CTS)
9 RING INDICATOR (RI)
• CN11 : Serial Port 14-pin Header( COM2)
Pin No. Description Pin No. Description
1 DCD 2 DSR
3 RXD 4 RTS
5 TXD 6 CTX
7 DTR 8 RI
9 GND 10 NC
11 RS422/RS485 TX2+ 12 RS422/RS485 TX2-
13 RS422 RX2+ 14 RS422 RX2-
16
Notes:If you want to use the RS485 mode that just connect to TX2-
,TX2+.If you want to use the RS422 mode that connect to TX2-
,TX2+,RX2+,RX2-.
3.9 IrDA Infrared Interface Port (CN12-1~5)
The JUKI-6752 built in a IrDA port which support Serial Infrared (SIR) .
When use the IrDA port have to set SIR model in the BIOS’s
Peripheral Setup’s COM2. Then the normal RS-232 COM2 will be
disabled.
•
CN12(PIN 1 ~5): IrDA connector
PIN NO. DISCRPTION
1 VCC
2 N/C
3 IRRX
4 Ground
5 IRTX