ICP Electronics JUKI-6752, Manual

Page: 3 / 21

1
1
Introduction
Welcome to the JUKI-6752 Pentium® with VGA Single Board
Computer. The JUKI-6752 board is an ISA form factor board, which
comes equipped with high performance and low power Pentium®
CPU and advanced high performance multi-mode I/O, designed for
the system manufacturers, integrators, or VARs that want to provide
all the performance, reliability, and quality at a reasonable price.
This board built-in Compact Flash Disk for embedded application.
The Compact Flash Disk is 100% compatible to hard disk. User can
use any DOS command without any extra software utility.
An advanced high performance super AT I/O chip – Winbond
W83977TF-AW is used in the JUKI-6752 board. Both on-chip
UARTs are compatible with the NS16C550. The parallel port and
IDE interface are compatible with IBM PC/AT and XT architecture's.
In addition, the JUKI-6752 provides one 144-pin SODIMM sockets
for its on-board SDRAM. The RAM module accepts 8MB, 16MB,
32MB,64MB,128MB or 256MB. So, the total on-board memory can
be configured to 256MB.
JUKI-6752 uses the advanced INTEL Chipset,430TX
which is 100% ISA/PCI compatible chipset.with PCI 2.1 standard.
2
1.1 Specifications :
The JUKI-6752 Pentium® with VGA Single Board Computer provides
the following specification:
•
CPU : Low power Pentium® MMX 166/266 MHZ(Tillamook PBGA)
• Bus : ISA bus
•
DMA channels : 7
•
Interrupt levels : 15
•
Chipset : Intel 430TX
•
PCI VGA : C&T 69000 with 2MB SDRAM built-in Chipset
Resolution : 1280x1024,256 color,60Hz
1024x768, 64K color,85Hz
800x600,full color,85Hz
•
Ethernet Interface :
Chipset : Intel 82559ER 100Base-TX Fast Ethernet Controller
Ethernet Interface : Onboard 100Base-TX RJ-45+LED Connector
•
H/W status Monitoring : Winbond W83782D H/W status monitoring
IC supports power supply voltages and temperatures monitoring
•
Real-Time Clock/Calendar : Intel 430TX chipset, backup by industrial
Li-battery,3V/300mAH. .
•
DRAM : supports up to 256MB,SDRAM.
•
Second Cache Memory : 512KB Pipelined Burst SRAM on board
•
Ultra DMA/33 IDE Interface : supports up to two PCI Enhance IDE hard
drives. The Ultra DMA/33 IDE can handle data transfer up to 33MB/s.
The best of all is that it is compatible with existing ATA-2 IDE
specifications. So there is no need to do any change for customer’s
current accessory.
• Floppy disk drive interface : two 2.88 MB, 1.44MB, 1.2MB, 720KB, or
360KB floppy disk drives.