VDX-6318 Windows Embedded Compact 7 - Getting Started Guide
Windows Embedded Compact 7 Getting Started Rev 2.00
Page 38
While the splash screen is showing, you can press “1” or “2” before the 10 seconds delay timed-out
to perform the following:
Press “1” to launch EBOOT.BIN to establish connectivity to the Platform Builder
development station and download OS run-time image from an active OS design.
Press “2” to launch the alternative OS run-time image, NK2.BIN.
Create Connectivity Profile for a Target Device
To establish connectivity and download Compact 7 OS run-time image from the development
station to the target device, you need to configure a target device connectivity profile and associate
the profile to the target device in use.
In this section you will work through the steps to create a target device connectivity profile and
associate this profile with the SBC, as the target device for the exercise in this guide.
Note:
The exercise in this section is applicable to development environment using dynamic IP addresses
with DHCP, and development environment using static IP addresses.
Continue from the previous exercise, with the
VDX6318
OS design project active, from the VS2008
menu, select
Target → Connectivity Options
to bring up the
Target Device Connectivity Options
screen, as shown in Figure 24.
Fig. 24 -
Target Device Connectivity Options
Work through the following steps to create a connectivity profile for the target device:
From the
Target Device Connectivity Options
screen, click
Add Device
to bring up the
screen to add a new target device profile as shown in Figure 25.