iCool TWIN Owner'S Manual Download Page 6

Page: 6 / 14

Owner’s manual for iCool Recovery Systems

STEP 5

Touch the start pump button. This will start the pump operating and
water should begin circulating.

NOTE: When you touch START buttons they change to STOP buttons
and can then be used to STOP that function if required.

It is essential that the water is flowing correctly before you touch the
start system button. The water flow is pre set to an optimum flow rate.
This allows time for the heat exchangers to operate at maximum cooling

efficiency. Pool water is completely changed approximately every 15 to

20 minutes. Do not touch the start system button until you are sure
that water is flowing smoothly. If water does not flow smoothly within
a minute or so, please check that the hose with the pump is flat on the
floor and no part of it is higher than the top of the water. Check that the
water in the pool is higher than the pump. If this does not correct the
problem the system will sound an alarm and a red warning screen will
appear with information about how to correct the water flow problem.

Main Operating Screen

Personal Logo Screens

Water Temperature Setting Screen

While the software is loading the status bars will flash white, the screen
shown above will be seen, then a black screen appears for about 15
seconds while the computers test the safety systems.

After the self test is completed, your personal logo screen or a standard
WELCOME screen will appear. Touching each screen anywhere will
stop the bars flashing and show a steady white light to indicate that the
systems checks were successful and that your iCool is ready to use.

The Status bars glow BLUE when only the pump is running, GREEN
when the cooling system is running and RED when the heating system
is running.

If the bars glow RED when you try to start cooling please refer to page
7 for an explanation.

Your twin is actually 2 separate iCool machines, so they can be operated
completely independently from each other. If you only want to use one
system, just ignore the other one, it will do no harm. Just touch the
screen of the unused one to stop the status light flashing.

If you ordered a personal logo screen your WELCOME screen will
look like the samples (right). Otherwise the standard iCool welcome
screen will appear. Touch your logo or welcome screen anywhere to
continue.

The Main Operating Screen will now appear

The main operating screen provides many options which are covered
elsewhere in this manual, however to quickly start the system you
can simply accept the default water temperature setting of 15ºC or,
to select a different temperature touch the CHANGE settings button.
Then 10ºC will be inserted automatically, but you can change to any
temperature you require at this point. Simply touch the up and down
arrow buttons and the desired pool water temperature will appear on
the bottom left-hand of the screen in the blue window marked “selected
temperature”. The right-hand side of the screen shows the outside air
temperature. The temperatures is in degrees centigrade, however it can
also be displayed in Fahrenheit. This is explained later in this Manual.

Once you have selected the pool water temperature you want for each
pool, touch the start buttons on each screen. This takes you back to the
main run screen which is the screen that you will use most of the time
during normal operation.