04
iCool Sport
CHECK YOUR POWER SUPPLY VOLTAGE
iCools can only be used with the voltage marked on the machine, they are not multi voltage. The voltage is marked next to the main power socket.
TO ENSURE SAFE OPERATION THE POWER OUTLET YOU USE MUST HAVE A PROPER EARTH CONNECTION.
BUILT IN SAFETY SYSTEMS
Your iCool system has many safety features to protect against such things as a loss of water flow, overheating of the system, or any chance of the
user receiving an electrical shock. If any such potentially dangerous things should occur, in most cases your iCool will shut itself down and a red
warning screen will appear to assist you to identify and correct the problem. In the case of overheating, the main fan will continue to run for some
time until the temperature is safely back to normal.
For the safety of users, any leakage of even a small amount of electrical current will cause the system to Instantly remove all electrical power. In the
unlikely event that your system shuts itself down for any of these reasons, you must identify and correct the problem that has caused the safety
systems to operate before allowing anyone to use the system.
PLEASE TEST THE EARTH LEAKAGE SAFETY DEVICE REGULARLY
The main power switch is also part of the electrical safety circuit that can prevent the possibility of electric shock. It is essential to test this safety
system each time you use the iCool to make certain it is operating correctly. This is very easy to do and takes only a few seconds. Turn on the main
switch and then press the orange test button just above the switch. If the safety system is working normally, pressing the test button will cause the
main power switch to shut off instantly. After a successful test, reset the main switch to ON to begin normal operation. If pressing the test button
fails to instantly shut off the power switch.
DO NOT USE THE SYSTEM until you contact iCool or a trained service person for advice.
Occasionally you may experience some difficulty getting the water to
flow correctly through your iCool due to trapped air in the system or
the hoses.
THE PUMP
Water flow through your iCool is produced by a high quality long life
circulating pump that includes an effective filter system to keep the
pool water clean. The pump with your iCool can not begin to operate
correctly unless it is fed with a head of water from a pool, therefore,
the level of water in the pool must be higher than the pump and any
air tapped in the feeding hoses must be removed. There must be no
air trapped in the supply hose from the pool to the pump and no part
of the hose from the pool to the pump can be above the level of the
water because this will trap air that can prevent water from flowing to
the pump. If you still do not have a good flow of water, with the pump
running, undo the levers on the snap hose fitting that connects the hose
from the top outlet point on the iCool. There is no need to remove the
fitting, just open the levers a little and this will allow any trapped air to
escape. As soon as you see water coming out of fitting, quickly snap it
back into position and lock it again.
YOU ONLY NEED TO BLEED AIR OUT OF THE SYSTEM ONCE
FOR EACH SET UP
Once primed of air, the system will remain primed and water will
normally flow instantly each time you start the pump until the pool is
emptied or the iCool is moved.
NEVER OPERATE THE PUMP WITHOUT WATER
Water pumps can not operate for long periods without water because
the water provides the lubrication to the bearings. To prevent damage,
your iCool system will shut down the pump automatically if water is
not flowing properly for more than 2 minutes. If this happens a warning
screen will normally appear to explain to you how to correct the problem.
VERY IMPORTANT INFORMATION ABOUT CHLORINE,
SALT & BROMIDE
All iCool Compact, twin and turbocool models are fitted with the latest
chemical and salt resistant Titanium Heat Exchanger tanks, however
we highly recommend that chlorine should only be used in very small
doses to prevent skin and eye irritation to pool users and to extend the
life of metal parts such as the circulating pump in your iCool. In cold
water, Chlorine is very effective in small doses of just 1.5 parts per
million, (1.5 ml per litre).
IMPORTANT
ADVICE
SAFETY NOTICE
OBTAINING THE CORRECT AMOUNT FLOW OF WATER
WARNING
Never use bromide or bromine based products, they are
extremely corrosive and can damage the metal parts
Summary of Contents for TWIN
Page 1: ...Owners Manual iCool TWIN ...
