9
6. Look under the Console Support (8) and identify
the Upper Wire (123), which has a larger con-
nector than the Extension Wire (124).
Connect the Upper Wire (123) to the Lower
Wire (122) extending from the Handlebar Post
(7). Tip: The wire connectors should slide
together easily and snap into place with an
audible click. If they do not, turn one connec-
tor and try again.
Then, connect the Extension Wire (124) to
the Control Wire (125) extending from the
Handlebar (97) in the same way.
8
7
97
122
125
124
6
123
7. Locate the two shipping screws (G) on the back
of the Console (10). Remove and discard the
shipping screws.
Have a second person hold the Console (10)
near the Console Bracket (11). Then, route the
wires (H) on the back of the Console through the
opening in the Console Bracket as shown by the
dashed line in the drawing.
Connect the wires (E) from the Console Support
(8) to the matching wires (H) on the back of the
Console (10). Tip: The wire connectors should
slide together easily and snap into place with
an audible click. If they do not, turn one con-
nector and try again.
Tip: Avoid pinching the wires (H, E). If neces-
sary, adjust the tilt of the Console Bracket
(11) to make this step easier. Attach the
Console (10) to the Console Bracket with four
M6 x 20mm Machine Screws (102); start all of
the Machine Screws, and then tighten them.
Note: This drawing is scaled to 90% compared to the
other assembly drawings and to the exploded drawing.
10
G
8
Avoid pinching
the wires (H, E)
7
102
102
G
11
H
H
E