Connecting your DT-air Active Studio Monitor System
DT-air Quick Connections
Note: Before plugging in and turning on, remember the "last on, first off"
rule of power amplifiers (and powered monitors). When powering up
your system, be sure that all the wires are connected, turn your mixer
and any other outboard gears on, and then finally turn on your DT-air
monitor.When powering down, turn your DT-air monitor system off first
and then your mixer and outboard gears.
The DT-air monitor system connection can be made via the balanced
input at the rear panel. You can use XLR ba4dBu level signals
input.
Follow the simple steps and diagram below for a quick connection using
a standard recording console's control room outputs (such as ICON's
imix).
Lower your mixer's master outputs as far down as possible.
Connect the mixer's left Control Room output to the left-side DT-air's
balanced input and the mixer's right Control Room output to the
right-side DT-air's balanced input.
Set the DT-air's input volume control to the 2 o'clock position. (The
volume setting is displayed on the LCD on the front panel)
Run an audio signal (such as some music from a CD) through your
mixer and raise the Control Room level to a comfortable listening level.
Mixer
DT-air series
Active Studio Monitor System
9
Summary of Contents for Definitor air Series
Page 18: ......
