Setting up your DT-air Active Studio Monitor System
Background on the DT-air Active Studio Monitor system
The DT-air is a near filed studio monitor featuring a custom design
with 5.25", 6.5" or 8.0" Nomex reinforced paper cone woofer and a 1" soft
fabric dome tweeter with a low-loss ferrofluid-free magnet system. The
monitor's crossover has been carefully designed by professional engineers
with high quality components, ensuring a linear frequency and phase
response. The DT-air enclosure is constructed from MDF. It is designed
with a tuned vent port that provides extended low-end response, and with a
low turbulence design. The low-frequency driver can move freely with
minimal effect on the overall impedance. On the rear of the
enclosure there is a XLR input connector. This is connected to the DT-air
internal Bi-Amp power module and provides power to the woofer and
tweeter. You will also find the pre-amp controls, including volume, used to
adjust the overall level of the internal power amplifier, as well as the
innovative Hi, Mid-range and Low presence control. These controls allow
the mix engineer to contour the Hi, Mid-range and Low response of the
monitor from traditional hi-fi sound to flat sound and then through two levels
of aggressive Hi, Mid-range and Low response. The DT-air has been
designed to provide flat, accurate monitoring, and at the same time, to
provide an adjustable response curve so that the sound of other popular
near field monitors can be easily emulated.
Positioning the DT-air monitor
Near field monitoring has become the choice
of many engineers in large and small studios
because it minimizes the effect of room
acoustics. By positioning the reference
monitors in the near field (close to the
listener), you can greatly reduce the effects
of room acoustics.
The most important considerations when
evaluating the effects of room acoustics are the reflective surfaces
around the monitoring area. These can include flat tabletops, glass
mirrors, framed pictures, large open walls and even the surface of your
mixing console. All reflecting sound will eventually reach the listening
position, but since it is slightly delayed from the direct source, the result
is random cancellation of some frequencies, or comb filtering. If possible,
remove any and all reflective surfaces. You may also want to attach some
acoustic foam to walls that are close to the monitors.
When positioning the monitors, you will want to set up what is commonly
referred to as the "mixing triangle". In this ideal configuration, the space
between the left and right monitor is equal to the distance from the
listener to each monitor, forming an equilateral triangle (as shown in Figure 1).
Equal
Distance
Figure 1
DT-air series
Active Studio Monitor System
7
Summary of Contents for Definitor air Series
Page 18: ......
