![background image](http://html1.mh-extra.com/html/icom/m400bb-sw/m400bb-sw_instruction-manual_3523304011.webp)
3
2
PREPARATION
New2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
New2001
The 10 digit ATIS (Automatic Transmitter Identification Sys-
tem) code can be programmed at power ON.
The code is programmed by using the HM-195.
This initial code setting can be performed only once.
After being set, it can be changed by only your dealer
or distributor. If your ATIS code has already been pro-
grammed, this programming is not necessary.
After programming the MMSI code, “Push [ENT] to Regis-
q
ter Your ATIS” is displayed.
Push [ENT] to start the ATIS code programming.
w
• Push [CLEAR] twice to cancel the programming, and go to the
normal operating mode. In this case, the ATIS function is dis-
abled. To program the ATIS code, turn OFF the power, then turn
it ON again.
Enter your ATIS code in the following manner:
e
• Select a desired number using Dial, or [
∫
]/[
√
]/[
Ω
]/[
≈
].
• Push [ENT] or Dial to set it.
• To move the cursor, select either arrow, “
←
” or “
→
,” then push
[ENT] or Dial.
Repeat step
r
e
to enter all 10 digits.
After entering the 10 digit code, “FINISH” is automatically
t
selected, and then push [ENT] or Dial to set it.
The “ATIS CONFIRMATION” screen is displayed.
y
Enter your ATIS code again for confirmation.
u
• Enter in the same manner as steps
e
through
t
.
When your ATIS code programming is successfully com-
i
pleted, the screen shown below is briefly displayed.
• After that, the normal operating screen is displayed.
The programmed ATIS code can be checked in the MENU
screen.
ATIS code programming
■
(For Dutch version transceivers)