![background image](http://html2.mh-extra.com/html/icom/id-800h/id-800h_firmware-update_3784351020.webp)
18
1
DIGITAL MODE OPERATION
New2001
■
Message items
D
D
TX message programming
TX messages are available for up to 6 channels and each
channel can be programmed with a message of up to 20
characters. Available characters are
0
to
9
,
A
to
Z
(capital let-
ters only)
, some symbols and space.
A TX message channel C1 must be programmed, if you want
to use the GPS message. The GPS message is transmitted
from channel C1 only.
q
Push
[SET•LOCK]
to enter message set mode.
• Rotate
[DIAL]
to select “MESSAG,” if “CALLS” or “SET” is dis-
played.
w
Push
[SET•LOCK]
or
[S.MW•MW]
several times until
“TXM-C” appears.
e
Push
[BAND•MODE]
then rotate
[DIAL]
to select the mes-
sage channel.
• One of either “C1” to “C6” blinks.
r
Push
[BAND•MODE]
for 1 sec. to enter message pro-
gramming mode.
• The 1st digit blinks and the channel indication stops blinking.
t
Rotate
[DIAL]
to select the desired character.
• Push
[SET•LOCK]
or
[S.MW•MW]
to move the cursor right or
left, respectively.
y
Push
[SET•LOCK]
to select 2nd digit, then rotate
[DIAL]
to
select the desired character.
• 2nd digit blinks (1st digit stops blinking).
• Repeat this step for programming.
u
Push
[BAND•MODE]
for 1 sec. to save the message.
i
Repeat steps
w
to
u
to set other message channels.
o
Push
[M/CALL•PRIO]
,
[TONE•T-SCAN•BK]
,
[LOW•DUP]
or
[MONI•DTMF•EMR]
to exit the message set mode.
ID-800H_FirmupInfo.qxd 05.10.27 9:08 Page 18 (1,1)