![background image](http://html.mh-extra.com/html/icom/ic-f9011/ic-f9011_user-manual_611377046.webp)
3
Push [Digital Button] again to enter the Short
Receiving
APCO P25 Mode Operation
3
Push [Digital Button] again to enter the Short
Message selection mode.
*A pre-programmed Short Message is displayed.
Receiving
▒
Not available on Non-display model.
1
When a Short Message is received;
• The Busy/Transmit lights green.
• The ringer sounds. (Depending on the pre-set
value.)
• The calling station ID name (or code) and the
Short Message blinks.
4
Push [CH Up] or [CH Down], or rotate
[CH Up/Down] to select the desired Short
Message. While in the Trunking mode, the
following steps
5
and
6
are not necessary.
Go to step
7
.
5
Push [Digital Button] (or [Digital Message]) again
g
2
A k
l d
i
i ll
i
d
The received message
The calling station ID name
5
Push [Digital Button] (or [Digital Message]) again
to enter the Individual ID selection mode.
• A pre-programmed ID name is displayed.
• When the ID name is not programmed,
the ID code is displayed.
2
An acknowledgement is automatically transmitted.
• The Busy/Transmit lights red.
3
Push any key (except for [ ]) to stop the display
from blinking and return to normal operation.
■
Status Query function
Transmitting
6
Push [CH Up] or [CH Down], or rotate
[CH Up/Down] to select the desired ID (or name).
• Push and hold [Digital Button] (or [Digital
Message]) for 1 sec to cancel and return to
Transmitting
A Status Query function allows you to send a signal
that requests the last transmitted Status Message
to the target station. The target station transceiver
automatically responds after receiving a Status
Query signal.
[Digital Button] key assignment is necessary to
transmit the Status Query.
Message]) for 1 sec to cancel and return to
normal operation.
• The ID can be edited with the 10-keypad*.
(Depending on the pre-set value.)
* 10-key model only.
7
Push [PTT] to transmit the Short Message to the
target station.
• The Busy/Transmit lights red.
▒
Not available on Non-display model.
1
Push [Digital Button] to enter the digital call type
selection mode.
2
Push [CH Up] or [CH Down], or rotate
[CH Up/Down] to select “STATUS QUERY.”
y/
g
• “PLEASE WAIT” is displayed.
8
Release [PTT].
• “ACK RECEIVED” is displayed after receiving an
acknowledgement from the target station, and
then the transceiver returns to normal operation.
• “NO ACKNOWLDG” is displayed when an
acknowledgement is not received, and then the
3
Push [Digital Button] again to enter the Individual
ID selection mode.
• A pre programmed ID name is displayed
46
transceiver returns to normal operation.
• A pre-programmed ID name is displayed.
• When the ID name is not programmed,
the ID code is displayed.