2
Push [Digital Button] again to enter the Individual
2
An acknowledgement is automatically transmitted.
APCO P25 Mode Operation
ID selection mode.
• A pre-programmed ID name is displayed.
• When the ID name is not programmed, the ID
code is displayed.
•The Busy/Transmit lights red.
3
Push any key (except for [ ]) to stop the display
from blinking and return to normal operation.
■
Radio Inhibit function
Transmitting
A Radio Inhibit function allows you to send a signal
3
Push [CH Up] or [CH Down], or rotate
[CH Up/Down] to select the desired ID (or name).
• Push and hold [Digital Button] or [Digital Page]
for 1 sec to cancel and return to normal
that will inhibit (stun or kill, depending on the pre-set
value) the target transceiver.
[Digital Button] key assignment is necessary to
transmit the radio inhibit signal.
▒
Not available on Non-display model in the
▒
Conventional P25.
✔
For Trunking mode operation:
for 1 sec to cancel and return to normal
operation.
• The ID can be edited with the 10-keypad*.
(Depending on the pre-set value.)
* 10-key model only.
4
Push [PTT] to transmit the pager signal to the
target station.
• The Busy/Transmit indicator lights red.
✔
o
g o e ope a o
This function is available only for a dispatcher in the
Trunking mode.
1
Push [Digital Button] to enter the digital call type
selection mode.
2
Push [CH Up] or [CH Down], or rotate
[CH Up/Down] to select “RDO INHIBIT.”
The Busy/Transmit indicator lights red.
• “PLEASE WAIT” is displayed.
5
Release [PTT].
• “ACK RECEIVED” is displayed after receiving an
acknowledgement from the target station, and
then the transceiver returns to normal operation.
• “NO ACKNOWLDG” is displayed when an
acknowledgement is not received, and then
3
Push [Digital Button] again to enter the Individual
ID l ti d
transceiver returns to normal operation.
Receiving
▒
Not available on Non-display model.
1
When a pager signal is received;
• The Busy/Transmit indicator lights green.
• The ringer sounds. (Depending on the pre-
tti
)
ID selection mode.
• A pre-programmed ID name is displayed.
• When the ID name is not programmed, the ID
code is displayed
.
setting.)
• “ ” blinks. (Depending on the pre-set value.)
• “PAGE RECEIVD” and the calling station ID
(or name) blink.
4
Push [CH Up] or [CH Down], or rotate [CH
Up/Down] to select the desired ID (or name).
• Push and hold [Digital Button] for 1 sec to
cancel and return to normal operation.
• The ID can be edited with the 10-keypad*.
41
The ID can be edited with the 10 keypad .
(Depending on the pre-set value.)
*10-key model only.
