![background image](http://html.mh-extra.com/html/icom/ic-f70ds/ic-f70ds_instruction-manual_612661026.webp)
22
4
BIIS OPERATION
D
D
Direct code entry
q
While in the standby condition, push [P3] (TX Code Enter)
to enter the TX code edit mode.
• Code digit for editing blinks.
w
Push [P3] (TX Code Enter) to select the desired digit to be
edited.
• Digit for editing differs according to the setting.
e
Set the desired digit using [CH Up]/[CH Down] or 10-key-
pad*.
*IC-F70DT/T or IC-F80DT/T only
r
Push [P3] (TX Code Enter) to set the digit, then the digit
to the right will blink automatically.
• When the 10-keypad is used for setting, the digit to the right will
blink automatically without pushing [P3] (TX Code Enter).
t
Repeat
e
and
r
to input all allowable digits.
y
Push [P0] (Call) or [PTT]* to call.
*PTT call can be made only when PTT call capability is permitted.
NOTE:
When no answer back is received, the trans-
ceiver repeats the call 3 times (default) automatically,
and
“
WAIT
”
is displayed during each call. However, an
error beep sounds and “
FAILED
”
is displayed when no
answer back is received after the calls.
u
Push [PTT] to transmit; release to receive.
i
Push [P4] (Moni(Audi)) to send the ‘Clear down’ signal.
For your information
When the “UpDate” setting for the call code is enabled, the
set code is overwritten into the call code memory.
X
IC-F70_F80-1.qxd 05.1.18 4:26 PM Page 22 (1,1)
Summary of Contents for IC-F70DS
