Icom IC-F70DS, Instruction Manual

Page: 25 / 48

21
4
BIIS OPERATION
4
■
Transmitting a call
A total of 3 ways for code selection are available—selecting
the call code from memory, entering the call code from the
keypad and calling back from the queue channel record.
D D
Using call memory
q
While in the standby condition, push [P1] (Digital) to enter
the call code memory channel selection mode.
• “ ” appears.
w
Push [Up] or [Down] to select the desired call code.
e
Push [P0] (Call) or [PTT]* to call.
*PTT call can be made only when PTT call capability is permitted.
NOTE: When no answer back is received, the trans-
ceiver repeats the call 3 times (default) automatically,
and “
WAIT
” is displayed during each call. However, an
error beep sounds and “
FAILED
” is displayed when no
answer back is received after the calls.
r
Push [PTT] to transmit; release to receive.
t
Push [P4] (Moni(Audi)) to send the ‘Clear down’ signal.
D D
Calling back from the queue channel
q
While in the standby condition, push and hold [P1] (Digital)
for 1 sec. to enter the queue memory channel selection
mode.
w
Push [Up] or [Down] to select the desired record.
e
Push [P0] (Call) or [PTT]* to call.
*PTT call can be made only when PTT call capability is permitted.
NOTE: When no answer back is received, the trans-
ceiver repeats the call 3 times (default) automatically,
and “
WAIT
” is displayed during each call. However, an
error beep sounds and “
FAILED
” is displayed when no
answer back is received after the calls.
r
Push [PTT] to transmit; release to receive.
t
Push [P4] (Moni(Audi)) to send the ‘Clear down’ signal.
X
X
Appears
IC-F70_F80-1.qxd 05.1.18 4:26 PM Page 21 (1,1)