Icom IC-F7000, Instruction Manual

Page: 34 / 68

5
31
CHANNEL/ID PROGRAMMING
■
Programming a channel
The IC-F7000 has up to 500 programmable channels
(400: regular, 100: ALE) with channel comment capa-
bility of up to 15 alphanumeric characters.
D D
Editing a channel
q
While pushing and holding [OK ≈ ≈ ] , turn power ON
to enter the Initial set mode .
w
Push [OK ≈ ≈ ] to edit ‘CH LIST.’
e
Push
[
∫ ∫
]
/
[
√ √
]
to select the desired channel or
‘<add>,’ then push
[OK ≈ ≈ ]
.
• Push [ Ω Ω CLR] to return the set mode menu.
• “
*
” marked channel is restricted for programming. Ask
your dealer.
• When existing channel is selected
r
Push
[
∫ ∫
]
/
[
√ √
]
to select the item or push
[ Ω Ω CLR]
/
[OK ≈ ≈ ]
to set the values or conditions for
each memory channel contents “Comment,” “RX
frequency,” “TX frequency,” “Call Type,” “Scan
group,” “Filter.”
• When <add> is selected
r
Edit a channel number by 10-keypad, then push
[OK ≈ ≈ ]
to enter the channel programming.
• If existing channel number is entered, this operation se-
lects a desired channel directly.
ç - -- CH- ____
-----RADTEL
è - MODE - USB
--- TX -03 . 760 . 0
--- RX -03 . 760 . 0
Push √ or ∫
ç - -- CH- 12
----- RADTEL
è - MODE - USB
--- TX - 03.760.0
--- RX - 03.760.0
é -TYPE- ç - TELCALL - å
-- FIL -- WIDE
-- SCAN - 2
-- DELETE - NO
--<add> ------------- -- å
---- 12 - RADTEL
è --- 15 - RADTEL
- * -- 13 - RADTEL
---- 14 - RADTEL
SET - MODE
--CH - LIST - - å
è - SCAN
-- ID - LIST -
-- I/O
[I/O] [ Ω CLR]/[OK ≈ ]
[ ∫ ]/[ √ ]