![background image](http://html1.mh-extra.com/html/icom/ic-f3062t/ic-f3062t_instruction-manual_4260650024.webp)
20
4
BIIS OPERATION
Direct code entry
D
While in the standby condition, push [TX Code Enter] to
q
enter the TX code edit mode.
• Code digit for editing blinks.
TXCE
CALL
TXC
BIFN
0500
Push [TX Code Enter] to select the desired digit to be ed-
w
ited.
• Digit for editing differs according to the setting.
Set the desired digit using [CH Up]/[CH Down] or 10-key-
e
pad*.
*IC-F3062T/IC-F4062T (10-key type) only
Push [TX Code Enter] to set the digit, then the digit to the
r
right will blink automatically.
• When the 10-keypad is used for setting, the digit to the right will
blink automatically without pushing [TX Code Enter].
Repeat
t
e
and
r
to input all allowable digits.
y
Push [Call] or [PTT]* to call.
* PTT call can be made only when PTT call capability is permit-
ted.
NOTE:
When no answer back is received, the trans-
ceiver repeats the call 3 times (default) automatically,
and
“
WAIT
”
is displayed during each call. However, an
error beep sounds and
“
FAILED
”
is displayed when no
answer back is received after the calls.
u
Push [PTT] to transmit; release to receive.
i
Push [Moni(Audi)] to send the ‘Clear down’ signal.
For your information
✓
When the “UpDate” setting for the call code is enabled, the
set code is overwritten into the call code memory.
Summary of Contents for IC-F3062T
Page 1: ...INSTRUCTION MANUAL iF4062T S UHF TRANSCEIVER iF3062T S VHF TRANSCEIVER...
Page 46: ...MEMO...
Page 47: ...MEMO...