70
8
SCANS
2001 NEW
■
Programmed scan/Fine programmed scan (VFO mode)
Programmed scan searches for signals between scan
edge memory channels P1 and P2. The default fre-
quencies for these memories are 0.500000 MHz and
29.99999 MHz, respectively. See p. 65 for scan edges
programming.
q
Push [V/M] to select VFO mode, if necessary.
w
Select the desired operating mode.
• The operating mode can also be changed while scan-
ning.
e
Push [TS] to select a tuning step.
• The tuning step can also be changed while scanning.
r
Push [MENU] to select
M2
.
t
Push [F1
SCN
] to select the scan menu.
• See p. 68 for scan condition.
• If the [RF/SQL] control function is set as “AUTO,” the
squelch is always open in SSB, CW and RTTY modes.
y
Push [F1
PRO
] to start the programmed scan.
• The MHz and kHz decimal points blink while scanning.
u
When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume, VSC
setting and the squelch condition.
i
To cancel the scan, push [F1
PRO
].
• Rotating the tuning dial during scan also cancels scan
operation.
If the same frequencies are programmed into the
scan edge memory channel P1 and P2, pro-
grammed scan does not start.
D
D
About the Fine programmed scan
During programmed scan, when a signal is received,
scan continues, but the tuning step is temporarily set to
10 Hz.
q
Follow steps
q
to
y
above to start programmed
scan.
w
During programmed scan, push [F3
FIN
] to switch
between programmed scan and fine programmed
scan operation.
e
Push [F1
PRO
] to cancel the scan.
• Rotating the tuning dial during scan also cancels scan
operation.
[
TS
]
Tuning dial
[MENU]
[
V/M
]
Mode keys
F 1
F 2
F 3
F 4
F 5
F 1
F 2
F 3
F 4
F 5
F 1
F 2
F 3
F 4
F 5
S C N M E M S W R T C N V S C
P R O
∂
F F I N S P N S E T
∂
F : ± 1 O k
P R O
∂
F F I N S P N S E T
P R O G S C A N
Push [F1]
Push [F1] to start/cancel the scanning.
Push [F1]
F 1
F 2
F 3
F 4
F 5
F 1
F 2
F 3
F 4
F 5
P R O
∂
F F I N S P N S E T
P R O G S C A N
P R O
∂
F F I N S P N S E T
F - P R O G S C A N
Push [F3] to switch
between programmed
scan and fine pro-
grammed scan.
IC-7400.qxd 02.4.2 11:35 Page 70
