![background image](http://html.mh-extra.com/html/icom/ic-208h/ic-208h_instruction-manual_611996028.webp)
13
2
SETTING A FREQUENCY
■
Tuning step selection
[
Tuning steps are the minimum frequency change increments
when you rotate [DIAL] or push [
Y
]/[
Z
] on the microphone.
Independent tuning step for each frequency bands can be set
for individual tuning convenience. The following tuning steps
are available.
• 5 kHz
• 10 kHz
• 12.5 kHz
• 15 kHz
• 20 kHz
• 25 kHz
• 30 kHz
• 50 kHz
• 100 kHz
• 200 kHz
☞
NOTE:
For convenience, select a tuning step that matches
the frequency intervals of repeaters in your area.
q
Push [BAND] to select the desired frequency band.
• Push [V/MHz•SCAN] to select VFO mode, if necessary.
w
Push [SET•LOCK] to enter set mode.
e
Push [SET•LOCK] or [S.MW•MW] several times until “TS”
appears as shown below.
r
Rotate [DIAL] to select the desired tuning step.
t
Push [V/MHz•SCAN] to exit set mode.
z
Push [BAND] to select the desired frequency
band.
• Push [VFO/LOCK] to VFO mode, if necessary.
x
Push [
SET
B(D-OFF)] to enter set mode.
c
Push [
SET
B(D-OFF)] or [
ENT
C(T-OFF)] several
times until “TS” appears.
v
Push [
Y
] or [
Z
] to select the desired tuning step.
b
Push [
CLR
A(MW)] to exit set mode.
SET
B
[SET•LOCK]