![background image](http://html2.mh-extra.com/html/icom/d-star-id-4100a/d-star-id-4100a_basic-manual_3514805070.webp)
55
9
MAINTENANCE
New2001
New2001
BASIC MANUAL
■
Troubleshooting
The following chart is designed to help you correct problems which are not equipment malfunctions.
If you are unable to locate the cause of a problem, or solve it through the use of this chart, contact your nearest Icom Dealer or
Service Center.
PROBLEM
POSSIBLE CAUSE
SOLUTION
REF.
Transceiver does not
turn ON.
•The power cable is improperly connected.
•A fuse is blown.
•Power source voltage is not correct.
•Reconnect the DC power cable correctly.
• Correct the cause, then replace the fuse
with an equivalent fuse. (Fuses are installed
in the DC power cable.)
•Apply the correct 13.8 V DC.
–
p. 54
–
No sound comes from
the speaker.
•The audio volume level is too low.
•The squelch is tightly closed.
• The tone squelch is ON in the FM mode.
• The external speaker is not connected.
•The audio is muted.
• Rotate [VOL] clockwise to obtain a suitable
listening level.
• Rotate [SQL] to the proper level to open the
squelch.
•Turn OFF the Tone squelch.
•Reconnect the external speaker.
• Hold down [MUTE] to release mute.
p. 19
p. 19
p. 20
p. 15
p. 10
Sensitivity is too low,
and only strong signals
are audible.
• The antenna is defective or the coaxial
cable connector is shorted or cut.
•The Attenuator function is turned ON.
•The squelch is set too tight.
• Correct the cause, then reconnect to the
antenna connector.
•Turn OFF the attenuator.
• Rotate [SQL] to adjust the squelch level.
–
p. 35
p. 19