iColor 700, User Manual

Page: 14 / 121

14
I3: Reg
Sensor
Back
This item configures the gap between back sensors. To access the I3: Reg Sensor Back menu, select the
UP arrow until I3: Reg Sensor Back is shown on the display.
To change the settings, hold down the
Menu key for about one full second until the * disappears. Use the
UP and DOWN arrow keys to set the required values. To save the values, press Menu . When all values
have been set, press and hold the Menu key for about one full second, until the * appears. The back
sensor or gap values are now set. To exit press the Menu button. Select On Line button to take the feeder
back online.
I4:
RSEN
Autocal
This item configures the auto calibration values. To access the I4: RSEN Autocal menu, select the UP
arrow until I4: RSEN Autocal is shown on the display.
To change the settings, hold down the
Menu key for about one full second until the * disappears. Use the
UP and DOWN arrow keys to set the required values. To save the values, press Menu . When all values
have been set, press and hold the Menu key for about one full second, until the * appears. The
autocalibration values are now set. To exit press the Menu button. Select On Line button to take the feeder
back online.
I5:
COTF
Paramet
ers
This item configures the parameters for Cut on the Fly. To access the I5: COTF Parameters menu, select
the
UP arrow until I5: COTF Parameters is shown on the display.
To change the settings, hold down the
Menu key for about one full second until the * disappears. Use the
UP and DOWN arrow keys to set the required values. To save the values, press Menu . When all values
have been set, press and hold the Menu key for about one full second, until the * appears. The COTF
parameter values are now set. To exit press the Menu button. Select On Line button to take the feeder
back online.
M3: Network Settings
The Network Settings menu items allow configuration of the IP Address, the Subnet Mask and the Default Gateway.
To access the M3: Network Settings menu, select
On Line to turn the feeder offline. Press the Menu key three times
for the M3: Network Settings menu to appear. The following items are under Network Settings:
I1: IP
Address
This item sets the IP Address. To access the I1: IP Address menu, select the UP arrow until I1: IP
Address is shown on the display.
To change the settings, hold down the
Menu key for about one full second until the * disappears. Use
the UP and DOWN arrow keys to set the required values. To save the values, press Menu . When all
values have been set, press and hold the Menu key for about one full second, until the * appears. The
IP Address now set. To exit press the Menu button. Select On Line button to take the feeder back
online.
I2:
Subnet
Mask
This item sets the Subnet Mask. To access the I2: Subnet Mask menu, select the UP arrow until I2:
Subnet Mask is shown on the display.
To change the settings, hold down the
Menu key for about one full second until the * disappears. Use
the UP and DOWN arrow keys to set the required values. To save the values, press Menu . When all
values have been set, press and hold the Menu key for about one full second, until the * appears. The
Subnet Mask is now set. To exit press the Menu button. Select On Line button to take the feeder back
online.
I3:
Gateway
This item sets the Default Gateway. To access the I3: Gateway menu, select the UP arrow until I3:
Gateway is shown on the display.
To change the settings, hold down the
Menu key for about one full second until the * disappears. Use
the UP and DOWN arrow keys to set the required values. To save the values, press Menu . When all
values have been set, press and hold the Menu key for about one full second, until the * appears. The
default Gateway now set. To exit press the Menu button. Select On Line button to take the feeder back
online.