Installation of custom door panel
This description concerns the model on which a decorative
door is installed.
①
Loosen the anchor screws on the lower hinge of the door
and separate the door.
②
Arrange the decorative door so that it matches the door
of the product.
③
Mark the center point of the top hinge and down hinge
holes that extend over the overlay panel. And then drill
3/8
”
diameter holes
¼”
deep at that point.
④
Remove the overlay panel from the door and tighten
the two M4×8 truss head screws securing the sheet
metal bracket to the overlay panel.
⑤
Separate the inside gasket of the door and fasten it by
inserting the four screws into the four holes at the
corners..
⑥
Fix the supplied door anchor bracket at the lower ends of
the door and decorative door.
⑦
Fix the completed door on the upper and lower hinge
and fasten the anchor screws of the lower hinge.
⑧
Check the operation of the door.
12
①
②
③
④
⑤
⑥
⑦
