3. Installation Instructions
Space requirements
When installing the ice maker, check that the electric power, and
piping position are correct. Refer to the installation specifications
and drawings shown on pages 7 and 8. Figures 4, 5, 6 and 7
show the entire dimensions of the product.
This product comes standard with a gravity drain connection that
requires a drain line to be run from the drain fitting at the back of
the product to appropriate water drain. The optional drain pump
can be installed to pump water to a higher drainage point, such
as a neighboring sink. Refer to the specifications shown on
pages 7 and 8.
Important Information: If the ice maker is installed in a corner,
the door may be hinged on the opposite side of the machine,
thereby avoiding any interference with a wall.
Important Information: The bottom of the ice maker should be
leveled
Important Information: When moving the product with a hand
truck or dolly, place the dolly at the side of the product and shut
or fix the door tightly to avoid possible opening during movement.
The finished bottom should be protected with a suitable material
to avoid possible damage when moving the product.
Requirements for power supply
120VAC, 60Hz, 15-amp circuit breaker and electric power are
required. Additionally, the provided 3-prong power cord should
be inserted into a suitable 3-prong, grounded outlet.
Important Information: A Ground Fault Circuit Interrupter (GFCI)
is not recommended because the operation of the product may
be stopped.
Important Information: The provisions of the National Electric
Code as well as any local laws and instructions should be
observed when installing the product.
Do not use extension codes or 2-prong adapters. The product
should be properly grounded. Do not cut the grounding terminal
off the 3-prong plug.
6
CAUTION
!
WARNING
!
Fig. 1 Front View
Fig. 2 Side View
Fig. 3 Top View
