icetro ISI-163SB, User Manual, Page: 12 / 32

12
Carburetor control
A small hole can improve the overrun, but it may depend on the amount of ingredients in
the mixing tank. The fewer ingredient is in the mixing tank, the higher the overrun becomes.
The more the ingredient is, the lower the overrun becomes.
The more the ingredients, the lower the overrun is.
information
For your
The carburetor has two components.
The one inserted into the hopper is "BODY," with a “TUBE" going
into the body.
The tube is open on both sides and cannot be inserted in the
wrong direction.
The carburetor hole is closed.
Match the projecting part on the upper “BODY" to the upper part
of the "TUBE" without a hole so that the hole in the lower part of the
"BODY" is plugged.
Conditions : When making ice cream for the first time to enhanced over run
After the ice cream is created, it should be changed
to small, midium or bigger hole.
The carburetor is set to a bigger hole.
Match the projecting part on the upper “BODY” to the big hole
in the upper part of the "TUBE" without a hole so that the hole in the
lower part of the "BODY" matches the big hole.
This is to minimize overrun and increase the ingredient for the
continuous making of ice cream.
Conditions : For operation
The carburetor is set to a smaller hole.
Match the projecting part on the upper “BODY” to the smaller
hole in the upper part of the "TUBE" without a hole so that the hole
in the lower part of the "BODY" matches the smaller hole.
This is to increase overrun and decrease the ingredient when
demand for ice cream is low.
Conditions : For operation
Even if overrun is improved with a smaller hole, the amount of ice cream may vary depending
on the amount of ingredient in the hopper.
The smaller the amount of ingredient that the hopper has, the bigger the overrun will become,
and vice versa.
For your
information
The carburetor is set to a medium-size hole.
Match the projecting part on the upper “BODY” to the medium-size
hole in the upper part of the "TUBE" without a hole so that the hole in
the lower part of the "BODY" matches the smaller hole.
This is to set medium overrun and ingredient.
Conditions : For operation
In normal use
Carburetor tube
Carburetor tube body