Icematic F 125C, Service Manual

Page: 12 / 48

10
9 Remove the manufacturer’s registration card
from the inside of the User Manual and fillin
all parts including: Model and Serial Number
taken from the data plate.
Forward the completed self-addressed regi-
stration card to CASTELMAC S.P.A.
Storage bin “D” series
1. Follow the steps 1, 2 and 3 above to unpack
the storage bin.
2 Unloose the two bolts and remove the pro-
tection plate from the drain fitting on model D
550.
3 Carefully lay it down on its rear side and fit
the four legs into their sockets.
4 Remove all internal support packing and
masking tape as well as the plastic ice cube
deflector which is not used with the ICEMA-
TIC Modular Flakers.
5 Remove the manufacturer’s registration card
from the inside of the User Manual and fillin
all parts including: Model and Serial Number
taken from the data plate.
Forward the completed self-addressed regi-
stration card to CASTELMAC S.p.A.
Storage bin “UD” series
1 Follow the steps 1, 2 and 3 above to unpack
the storage bin.
2 Lay carefully down the bin on its back to pro-
tect the finish and remove the bolts holding
the shipping skid to the bin.
3 Screw-in the legs into the corresponding tap-
ped holes in the bin bottom and tighten to
seat the legs well against the bin bottom.
4 Connect the water drain line to the male drain
fitting located in the bottom of the bin.
5. Insert the longer side of each plastic inspec-
tion window in the upper track of the corre-
sponding opening and push it to force the
window to enter into its seat.
KN and KF Top Covers
1 Follow the steps 1 and 2 above to unpack the
top cover.
2 Cut open the carton box and pull out the KF
Top Cover.
3 On KF 48/52 FMCD Top Covers, the ice drop
area must be cutted on the plastic cover in
the same position of the ice machine ice
chute opening.
C. LOCATION AN LEVELLING
CAUTIONS. Avoid excessive tightening
force when connecting to this fitting.
Do not apply excessive heat if any
sweating of the fittings is necessary. Heat
conduction through the metal may melt
the threads in the plastic drain.
WARNING. This Modular Flaker and
Superflaker is designed for indoor
installation only. Extended periods of
operation at temperature exceeding the
following limitations will constitute
misuse under the terms of the SCOTSMAN
Manufacturer’s Limited Warranty resulting
in LOSS of warranty coverage.