Manual de Operação - SONOPEEL
1
a
edição (10/2009)
10
SONOPEEL
– POWER SUPPLY
SONOPEEL
single phase equipment which can be operated on voltages
ranging from 100-240 volts 50/60 Hz. The selection of the tension is
automatic , so there is no need to be worried with the local tension. The cable
to the power network is detachable. The equipment uses the plug network as a
resource to separate its circuits electrically in relation to the electrical network in all
poles.
To change it,
unplug the power outlet
and with the help of a small
screwdriver, remove the protection cover, disconnect the fuse, substitute it
and put the cover back again.
Always use the fuses indicated by IBRAMED
:
Use the 5.0A fuse for nominal current, operating voltage 250V~
and fast action model 20AG (breaking current of 50A).
SECURITY RISKS MAY OCCUR IF THE EQUIPMENT IS NOT PROPERLY
INSTALLED.
Notes:
1-
There are dangerous voltages within the equipment. Never open the
equipment.
2-
SONOPEEL
does not need any kind of stabilizer. Never use power stabilizer.
Before connecting
SONOEEL
, be sure that:
The voltage and the frequency of the electrical network in the place where
the equipment will be installed are the same as described on the label of the
voltage and power network in the back of the equipment.
To prevent electrical shock, do not use the plug of the device with an
extension cable, or any other outlets, unless the terminals are fully inserted
into the receptacle.
