IBM TS2280, Setup, Operator, And Service Manual

Page: 75 / 142

The best storage container for the cartridges (until they are opened) is the original shipping container.
The plastic wrapping prevents dirt from accumulating on the cartridges and partially protects them from
humidity changes.
When you ship a cartridge, place it in its jewel case or in a sealed, moisture-proof bag to protect it from
moisture, contaminants, and physical damage. Ship the cartridge in a shipping container that has enough
packing material to cushion the cartridge and prevent it from moving within the container.
Table 14 gives the environment for operating, storing, and shipping LTO Ultrium Tape Cartridges.
Table 14. Environment for operating, storing, and shipping the LTO Ultrium Tape Cartridge
Environmental Specifications
Environmental Factor Operating Operational Storage
1
Archival Storage
2
Shipping
Temperature 10 - 45°C (50 - 113°F) 16 - 32°C (61 - 90°F) 16 - 25°C (61 - 77°F)
-23 to 49°C (-9 to
120°F)
Relative humidity
(non-condensing)
10 - 80% 20 - 80% 20 - 50% 5 - 80%
Maximum wet bulb
temperature
26°C (79°F) 26°C (79°F) 26°C (79°F) 26°C (79°F)
Note:
1. The short term or operational storage environment is for storage durations of up to six months.
2. The long term or archival storage environment is for durations of six months up to 10 years.
Disposing of tape cartridges
Under the current rules of the US Environmental Protection Agency (EPA), regulation 40CFR261, the LTO
Ultrium Tape Cartridge is classified as non-hazardous waste. As such, it might be disposed of in the same
way as normal office trash. These regulations are amended from time to time, and you must review them
at the time of disposal.
If your local, state, country (non-US), or regional regulations are more restrictive than EPA 40CFR261, you
must review them before you dispose of a cartridge. Contact your account representative for information
about the materials that are in the cartridge.
If a tape cartridge must be disposed of in a secure manner, you can erase the data on the cartridge with a
high-energy ac degausser (use a minimum of 4000 oersted peak field over the entire space that the
cartridge occupies). The tape must make two passes through the field at 90 degree orientation change for
each pass to achieve complete erasure. Some commercial degaussers have two magnetic field regions
offset 90 degrees from each other to accomplish complete erasure in one pass for higher throughput.
Degaussing makes the cartridge unusable.
If you burn the cartridge and tape, ensure that the incineration complies with all applicable regulations.
Ultrium media
53