Table 9. POST error messages (continued)
POST message
Description
289
An error occurred during POST memory tests and a failing DIMM was disabled.
Note: You can use the appliance with decreased memory.
Action:
1. If you just installed memory, verify that the new memory is correct for your appliance. Also
verify that the memory is installed and seated correctly. Start the Configuration/Setup Utility
program and select Memory Settings from the Advanced Setup menu to enable the
DIMM.
2. If the problem remains, replace the failing DIMM.
If the problem persists, call for service.
301 303
An error occurred during the keyboard and keyboard controller test. These error messages
also might be accompanied by continuous beeping.
Action: Ensure that:
1. Nothing is resting on the keyboard and pressing a key.
2. No key is stuck.
3. The keyboard cable is connected correctly to the keyboard and to the correct connector on
the appliance.
Running the diagnostic tests can isolate the appliance component that failed, but you must
have your system serviced. If the error message remains, call for service.
Note: If you just connected a new mouse or other pointing device, turn off the appliance and
disconnect that device. Wait at least 5 seconds; then, turn on the appliance. If the error
message goes away, replace the device.
602
Invalid diskette boot record
Action:
1. Replace the diskette.
2. If the problem persists, make sure that the diskette drive cables are correctly and securely
connected.
3. If the problem remains, replace the diskette drive.
If the problem persists, call for service.
604
An error occurred during a diskette drive test.
Action:
1. Verify that the Configuration/Setup Utility program correctly reflects the type of diskette
drive that you have installed.
2. Run the diagnostic tests. If the diagnostic tests fail, call for service.
662
A diskette drive configuration error occurred.
Action: If you removed a diskette drive, make sure that the diskette drive setting is correct in
the Configuration/Setup Utility program. If the setting is not correct, change it.
If the problem persists, call for service.
962
A parallel port configuration error occurred.
Action: If you changed a hardware option, make sure that the parallel port setting is correct in
the Configuration/Setup Utility program. If the setting is not correct, change it.
If the problem persists, call for service.
Appendix D. POST error messages
57
Summary of Contents for TotalStorage Network Attached Storage 300G
