IBM TotalStorage FAStT200, Installation And User Manual

Page: 57 / 114

Chapter 5. Installing and replacing components
39
4. Remove the filler panel.
a. Insert a finger into the square hole at the top of the filler panel to grip and pull
the tray out of the drive bay.
b. Save the filler panel for later use.
5. Install the drive CRU:
Note: The hard disk drive comes with a tray already attached. Do not attempt to
detach the drive
򐂰
4
򍦠
from the tray
򐂰
3
򍦠
.
a. Release the blue latch 򐂰
1
򍦠 on the drive CRU by pressing on the inside of the
bottom of the tray handle.
b. Pull the handle 򐂰
2
򍦠 on the tray out into the open position.
c. Slide the drive CRU into the empty bay until the tray handle 򐂰
2
򍦠 touches the
storage-server bezel.
d. Push the tray handle
򐂰
2
򍦠
down into the closed (latched) position.
6. If you are installing a slim drive, continue with step 6a. Otherwise, go to step 7.
a. Locate the filler piece on the inside of the filler panel.
b. Pull up on the small latch
򐂰
1
򍦠
inside the filler panel to release the filler piece.
c. Tilt the filler piece up from the filler panel 򐂰
2
򍦠 ; then, remove it from the tray as
shown in the following illustration.