IBM TotalStorage 3534-F08, Installation Manual

Page: 30 / 81

Table 6. Parts supplied with the rack mount kit (continued)
Item Description Quantity
7
Screw, M5 x 12 11
8
Bracket to slide rack kit (contains items 9 - 12) 1
9
Screw, 8-32 x 3/8 in., zinc 5
10
Washer, flat, No. 8 5
11
Washer, lock, No. 8 5
12
Nut, hex, 8-32 5
Note: Because this rack mount kit is distributed with various switches, you might end up
with extra parts that are not needed for the installation of your switch into your rack
assembly.
2. Separate the inner and outer slides.
a. Open one of the slides until the lock engages.
b. Press the lock release lever and remove the inner rail from the outer rail, as
shown in Figure 7.
c. Repeat steps 2a - 2b for the other rail.
Note: For racks with flush-mount doors such as the 9306 Netfinity
®
racks, you
can eliminate the installation of the ears. Instead, use the rack-mount
slides by attaching the 3534 Model F08 to the set of mounting holes,
which are offset 2.62 cm (3 in.) into the rack.
3. Install the inner (smaller) slide on the 3534 Model F08 chassis.
a. Position the flat side of the inner rail along one side of the switch, aligning
the holes in the rail with the threaded holes in the side of the switch chassis.
The chamfered end of the inner rail should face toward the rear of the
switch (away from the ports) as shown in Figure 8 on page 13.
b. Attach the inner rail using two of the 8-32 x 3/16 in. zinc screws
6
.
Attention: Using screws longer than 3/16 in. can damage the switch.
c. Repeat steps 3a - 3b for the second inner rail on the other side of the switch
chassis.
SJ000046
1
Figure 7. Moving slide
12
IBM TotalStorage
™
SAN Fibre Channel Switch: 3534 Model F08 Installation Guide