4.
Attach the devices.
Cable Connectors
If cable connectors are
fastened together with a
twist-tie, undo the twist-tie
and separate them.
Go to the applicable step.
Device to Install
Go to Step
CD-ROM drive
4a on page 47
SCSI device
4b on page 48
ThinkPad hard disk drive
4c on page 49
Tape backup unit
4d on page 50
a)
To attach the CD-ROM drive,
do the following:
Insert the CD-ROM drive into
the 1-inch-high compartment.
Leave enough space in the back
of the drive so the cables can be
connected.
Insert the three connectors
1
of the cables in the Dock II to
the corresponding connectors of
the CD-ROM drive.
While pressing the connected
cables down so that they are not
above the CD-ROM drive, push
in the CD-ROM drive until it
completely stops and is latched.
Latch
If you need to remove
devices, you must release
the latch. See “Releasing the
Latch” on page 71.
CAUTION:
i. This CD-ROM drive uses a laser system. To ensure
correct use of this product, read the manual that came
with the CD-ROM drive carefully and keep the
manual for future reference. If the unit requires
maintenance, have it serviced by authorized
personnel.
ii. Use of controls, adjustments or the performance of
procedures other than those specified may result in
hazardous radiation exposure.
iii. To prevent direct exposure to the laser beam, do not
open the enclosure.
1
Chapter 4. Installing and Removing IBM Options
47
Title: C78JAMST CreationDate: 05/06/94 19:15:58
All manuals and user guides at all-guides.com
