IBM System x3755 M3 7164, Installation And User Manual

Page: 86 / 126

Microprocessor
0.02 mL of thermal
grease
5. Use the thermal-grease syringe to place 9 uniformly spaced dots of 0.02 mL
each on the top of the microprocessor. The outermost dots must be within 5 mm
of the edge.
Note: 0.01mL is one tick mark on the syringe. If the grease is properly applied,
approximately half of the grease will remain in the syringe.
6. Install the heat sink onto the microprocessor as described in “Installing a
microprocessor” on page 64.
Completing the installation
To complete the installation, complete the following steps:
1. If you removed the PCI riser-card assembly, replace it (see “Installing the PCI
riser-card assembly”).
2. If you removed the air baffle, replace it (see “Installing the air baffle” on page
69).
3. If you removed the top cover, replace it(see “Installing the top cover” on page
71).
4. If you removed the top-cover fan door, replace it (see “Installing the top-cover
fan door” on page 71).
5. Install the server in a rack. See the Rack Installation Instructions that come with
the server for complete rack installation and removal instructions.
6. Connect the cables and power cords to the rear of the server. For more
information, see “Connecting the cables” on page 72.
7. (IBM Business Partners only) Complete the additional steps in “Instructions for
IBM Business Partners” on page 19.
Installing the PCI riser-card assembly
To install the PCI riser-card assembly, complete the following steps:
1. Make sure that all internal cables are correctly routed and that no cables are
pinched.
2. Align the PCI riser-card assembly with the PCI connectors on the system board
and align the nailheads with the slots on the chassis; then, lower the PCI
riser-card assembly into the server.
68
IBM System x3755 M3 Type 7164: Installation and User’s Guide