IBM System x3755 M3 7164, Installation And User Manual

Page: 33 / 126

v
Reset button: Press this button to reset the server and run the power-on
self-test (POST). You might have to use a pen or the end of a straightened paper
clip to press the button. The reset button is in the lower-right corner of the light
path diagnostics panel.
For more information about light path diagnostics, see the Problem Determination
and Service Guide on the IBM Documentation CD.
Rear view
The following illustration shows the connectors on the rear of the server.
DC
!
AC
Power
connector
System
serial
Video
Gigabit
Ethernet 1 4
connectors
-
USB 3
connector USB 4
connector System
management
Ethernet
Power-cord connector: Connect the power cord to this connector.
System-management connector: Use this connector to connect the server to a
network for systems-management information control. This connector is used only
by the integrated baseboard management controller (iBMC).
USB connectors: Connect USB devices, such as a USB mouse or keyboard, to
these connectors.
Video connector: Connect a monitor to this connector.
Serial connector: Connect a 9-pin serial device to this connector. The serial port is
shared with the integrated baseboard management controller (iBMC). The iBMC
can take control of the shared serial port to perform text console redirection and to
redirect serial traffic, using Serial over LAN (SOL).
Gigabit Ethernet connectors: Use these connectors to connect the server to a
network. When you enable shared Ethernet for iBMC in the Setup utility, you can
access the iBMC using either the Ethernet 1 or the system-management Ethernet
connector.
Chapter 1. The System x3755 M3 server
15