IBM System x3755 M3 7164, Installation And User Manual

Page: 90 / 126

Latch
Latch
2. Press the release latches on the top-cover fan door to lock it in place.
3. If necessary, reconnect the power cords and all external cables, and then turn
on the server.
4. Slide the server into the rack.
Connecting the cables
Notes:
1. Be sure to turn off the server before you connect any cables to or disconnect
any cables from the server.
2. For additional cabling instructions, see the documentation that comes with the
optional devices. It might be easier for you to route any cables before you install
certain optional devices.
The following illustration shows the locations of the input and output connectors on
the rear of the server.
DC
!
AC
Power
connector
System
serial
Video
Gigabit
Ethernet 1 4
connectors
-
USB 3
connector USB 4
connector System
management
Ethernet
Updating the server configuration
When you start the server for the first time after you add or remove a device, you
might receive a message that the configuration has changed. The Setup utility
starts automatically so that you can save the new configuration settings. For more
information, see Chapter 3, “Configuring the server,” on page 75.
72
IBM System x3755 M3 Type 7164: Installation and User’s Guide