IBM System x3100 M4, Problem Determination And Service Manual

Page: 267 / 332

Hot-swap
power supply
Release
lever
3. Connect one end of the power cord into the connector on the back of the power
supply and connect the other end of the power cord into a properly grounded
electrical outlet.
4. Make sure that both the ac and dc power LEDs on the rear of the power supply
are lit, indicating that the power supply is operating correctly.
5. If you are adding a power supply to the server, attach the redundant power
information label that comes with this option on the server top cover near the
power supplies.
1
xxx-xxx/
xxx-xxxV~
2
XXXW ~ AC
x,x/x,x A
xx/xx Hz
xxx-xxx/
xxx-xxxV~
XXXW ~ AC
x,x/x,x A
xx/xx Hz
Removing the hot-swap power supply cage
This procedure applies only to the 5U server model with hot-swap power supplies
(Model name: 2582-F4x).
Chapter 5. Removing and replacing server components
247