IBM Storwize V7000, Introduction And Implementation Manual

Page: 276 / 670

256
IBM Flex System V7000 Storage Node Introduction and Implementation Guide
6.1 Storage provisioning from IBM Flex System V7000 Storage
Node
This section follows the setup process and shows how to create volumes and make them
accessible from the host. The following steps are required to complete the basic setup of your
environment:
򐂰 Create new volumes: starting at section 6.1.1, “Creating a generic volume” on page 258
򐂰
Create a new host: starting at section 6.2, “Creating a new host” on page 273
򐂰 Map volumes to the host: at section 6.3, “Mapping a volume to the host” on page 279
Discovery of the volumes from the host and multipath settings are discovered in Chapter 12,
“Host configuration” on page 511.
Open the Volumes window of the IBM Flex System V7000 Storage Node GUI (Figure 6-1)
to start the process of creating new volumes.
Figure 6-1 Home window with Volumes highlighted