IBM Storwize V7000, Introduction And Implementation Manual, Page: 267 / 670

Chapter 5. IBM Flex System V7000 Storage Node GUI interface
247
5.9.3 Network menu
The network setup for all the interfaces in the cluster is configured here.
Clicking Network opens the window shown in Figure 5-64. From here you can update the
network configuration, set up iSCSI definitions, and view information about the Fibre Channel
connections.
Figure 5-64 Network window
Service IP addresses
The Service IPs are IP addresses of each of the two IBM Flex System V7000 Storage Node
controllers called canisters. These controllers have their own IP addresses where several
support actions can be performed. Some of them are listed here:
򐂰 Place a canister in Service State.
򐂰 Power cycle a canister.
򐂰 Clear all system configuration data.
򐂰 Create a new cluster.
򐂰 Recover a failed system (action ONLY performed by IBM Support).
򐂰 Upgrade firmware manually with controllers offline.
򐂰 Extract system event logs.
Tip: The Service IP addresses are normally not used by the IBM Flex System V7000
Storage Node administrator. They are used ONLY as part of the initial installation
procedure or when IBM Support performs certain service actions.