IBM SAN384B, Installation, Service And User Manual

Page: 106 / 183

Installing a blower assembly
To install a blower assembly, do the following:
1.
Orient the blower assembly and slide it into the chassis, pushing firmly to
ensure that it is seated.
2. Verify that the power LED displays a green light.
3. Use the screwdriver or your fingers to tighten the captive screws.
Removing and installing a WWN bezel and WWN card
Note: The World Wide Name (WWN) cards contain fully redundant circuits and
normally do not require replacement. Two WWN cards are located beneath
the WWN bezel.
Time and items required
Allow approximately 20 minutes to install a WWN card. The following items are
needed to install a WWN card:
v
ESD grounding strap
v #2 Phillips screwdriver (required only for some versions of the WWN card)
384b023
Figure 39. Blower assembly removal and replacement
78
SAN384B Installation, Service, and User Guide