IBM SAN384B, Installation, Service And User Manual

Page: 44 / 183

7. Attach the 24-inch load plate, by slipping the top curved portion under the
horizontal bar, and resting the load plate on the forks.
8.
Attach the anti-tip bars (recommended to provide additional stability when
the loaded lift tool is raised more than 45 cm (18 in) high). Install these from
the rear of the lift tool, by sliding them inside the horizontal legs, pulling up
on the leg lock pins to allow the pins to engage the holes in the legs and the
anti-tip bars.
9. Secure the anti-tip brackets to the lift tool with the supplied brackets and
bolts.
10. The lift plate has a middle section that can be extended to the right (when
viewed from the back of the lift tool). This middle section is secured in place
by two spring-loaded pins. Familiarize yourself with releasing the pins and
sliding this section. There are two stops: half-way extended and fully
extended. This middle section will need to be fully extended during the
installation to safely span the gap between the lift tool and the cabinet
mounting position.
11. Move the assembled lift tool and retention straps near the equipment to be
installed. Figure 4 shows the assembled lift tool with the 24-inch load plate
installed.
Unpacking the SAN384B
svc00169
55 kg ( 121.2 lbs)
CAUTION:
The weight of this part or unit is more than 55 kg (121.2 lb). It
takes specially trained persons with a lifting device to safely lift
this part or unit. (C011)
To unpack the SAN384B, follow these steps:
Figure 4. Assembled lift tool with 24-inch load plate
16
SAN384B Installation, Service, and User Guide