IBM SAN Volume Controller 2145-CF8, Hardware Installation Manual

Page: 40 / 101

3.
Position the redundant ac-power switch in the rack first, pushing the cables
through to the front of the rack. Mount in place, as shown in Figure 7, using
the four M6 screws.
Connecting the redundant ac-power switch to the site power
You must connect the redundant ac-power switch to the site power before you test
the redundant ac-power switch.
Perform the following steps to connect the redundant ac-power switch to the site
power:
1. Determine a suitable cable route from the redundant ac-power switch to the
power distribution units.
2. Route the main input-power cable of the redundant ac-power switch to the
specified power distribution unit, and connect it.
3. Route the backup input-power cable of the redundant ac-power switch to the
specified power distribution unit, and connect it.
4. Verify that the redundant ac-power switch power cables are tidy. Ensure that
they do not obstruct other equipment and that they are tied in place where
necessary.
svc00292
Figure 6. Positioning the clips
Figure 7. Positioned in rack
14
IBM System Storage SAN Volume Controller: Model 2145-CF8 Hardware Installation Guide