IBM SAN Volume Controller 2145-CF8, Hardware Installation Manual

Page: 58 / 101

cable assemblies that were supplied with previous SAN Volume
Controller models do not work with the 2145-CF8 model because there
are two power cables in the bundle for the 2145-CF8 model. The correct
part is differentiated by the blue tape that binds the cables together.
Before you begin this task, see the completed customer’s cable-connection table,
which is described in the
IBM System Storage SAN Volume Controller Planning Guide
and can be downloaded from www.ibm.com/storage/support/2145.
Use the information in this table to identify the 2145 UPS-1U unit to which this
node is to be connected.
Perform the following steps to connect the SAN Volume Controller to the 2145
UPS-1U:
1. At the back of the SAN Volume Controller 2145-CF8 node, plug the power
cables of the combined power and serial cable assembly into the power
connector
2
, as shown in Figure 32.
1
Fibre-channel ports
2
Power connector
3
Serial connector
4
Ethernet ports
5
Main-power connector
6
Communication port
7
Load-segment 2 receptacle
2.
Place the other end of the power cables into the load-segment 2 receptacles
7
on the 2145 UPS-1U.
svc00540
4
7
3 1
2
6 5
Figure 32. Connecting the SAN Volume Controller 2145-CF8 power cable to the 2145
UPS-1U
32
IBM System Storage SAN Volume Controller: Model 2145-CF8 Hardware Installation Guide