IBM Remote Supervisor Adapter, User Manual, Page: 96 / 124

If DHCP is enabled, the host name, IP address, gateway address, subnet
mask, and DNS server IP address are set automatically.
14. Press F3 until you reach the Network Interfaces/Protocols window and then
select Restart ASM .
Configuring PPP access over the serial port
Use the point-to-point protocol (PPP) access method if you do not have Ethernet
access. You can use PPP through your serial port to enable access to the Remote
Supervisor Adapter through a Telnet session or a Web browser.
Note: If you enable the PPP interface, the Remote Supervisor Adapter cannot use
the serial port for serial remote access.
1. Log in to the Remote Supervisor Adapter. For more information, see
“Accessing the text-based interface through a Telnet connection” on page 65 or
“Accessing the text-based interface through a direct serial connection” on
page 66.
2. In the Advanced System Management window, select Settings . The Settings
window opens.
3. In the Settings window, select Network Interfaces/Protocols . The Network
Interfaces/Protocols window opens.
4. In the Network Interfaces/Protocols window, select PPP . The PPP window
opens.
Note: The values in the following window are examples. Your settings will be
different.
5. In the Interface field, select Enabled .
6. In the Local IP address field, enter the local address for the PPP interface on
this Remote Supervisor Adapter. The field defaults to 192.96.1.1. The IP
address must contain:
v Four integers from 0 through 255 separated by periods
v
No spaces
90
Remote Supervisor Adapter: User’s Guide