IBM Remote Supervisor Adapter, User Manual, Page: 93 / 124

MNP microcom networking protocol
RTS ready to send
Configuring network interfaces
With the network interface options, you can set access to the Remote Supervisor
Adapter by:
v Configuring an Ethernet connection to a Remote Supervisor Adapter
v
Configuring point-to-point protocol access over a serial port
Configuring an Ethernet connection to the Remote Supervisor Adapter
Complete the following steps to configure your Ethernet setup:
1. Log in to the Remote Supervisor Adapter. For more information, see
“Accessing the text-based interface through a Telnet connection” on page 65 or
“Accessing the text-based interface through a direct serial connection” on
page 66.
2. In the Advanced System Management window, select Settings . The Settings
window opens.
3. In the Settings window, select Network Interfaces/Protocols . The Network
Interfaces/Protocols window opens.
4. Select Ethernet . A window similar to the following opens.
Chapter 7. Configuring your Remote Supervisor Adapter using a text-based interface
87