IBM Power Systems 8247-42L, Manual

Page: 112 / 228

18.
Install the heat sink in the replacement system backplane:
a. Lower the heat sink over the system processor module, ensuring that the two guide pins (B) are
inserted into the alignment holes on each side of the tool, as shown in Figure 96 on page 95.
b. Ensure that the heat sink load arm is engaged.
Note: If the load arm is not engaged, you must manually engage the load arm onto the heat sink
while the load screw is being tightened. See Figure 97 on page 96.
A
P8EDE517-2
Figure 95. Installing the TIM onto the processor lid
94
System backplane