IBM NetVista, Hardware Maintenance Manual

Page: 56 / 155

56
If a newly replaced FRU does not correct the problem:
If you have reached this point of the check procedures and were
instructed to replace a FRU but doing so did not correct the problem, reinstall the original FRU and go through "Start" again.
If you want to print a copy of a BIOS Setup Utility screen to an attached printer, press
Print Screen
key, while the screen is
displayed.
PLEASE READ THE FOLLOWING:
Human Error is a cause for concern when applied to check procedures. It exists in every first time set of
analysis procedures. It is therefore essential for effective and time-efficient servicing that each stage of
every procedure be verified. (For example: When a symptom is found, or when a symptom appears to
have been cured; the preceding steps should be repeated for accuracy of analysis.)
001 - START
To begin, note the following:
Disable the setting of “Quick Power-On Self Test” from BIOS Setup.
Disconnect all external cables and devices including speakers and microphone from the system unit, except for the
keyboard, mouse, and monitor.
Power off the system unit before moving it or when replacing FRUs.
Remove all adapter cards, except for the factory-installed modem adapter card and any other IBM factory-installed
adapter cards.
Disconnect any drives except:
■ 3.5-in. diskette drive
■ Hard disk drive
■ Factory-installed devices (such as a CD-ROM drive)
Make sure that all power cords and cables are connected properly.
Make sure that the monitor brightness and contrast controls are not turned down.
Power on the system unit.
NOTE:
Some monitors have a detachable system I/O signal cable between the monitor and the system unit. In this case,
check this signal cable before replacing the unit. See “Monitor Port Signals” on page 130 for pin identification.