IBM NetVista, Hardware Maintenance Manual

Page: 48 / 155

48
3.Highlight the Save & Exit Setup Option, then press Enter. A dialog box appears
SAVE to CMOS and EXIT(Y/N)?
Load Optimized Defaults
When you purchase an IBM personal computer, it is already configured for use. The original configuration settings, also
called factory or default settings, are stored in the CMOS. Setup includes an option Load Optimized Default Settings that
allows you to reload the original configuration at any time.
If you have made changes in Setup but would like to restore the default settings, follow these steps:
1. From the main menu, highlight the option Load Optimized Default Settings then press Enter. A dialog box appears
confirming if you want to load the default settings.
2. Type
Y
to select YES, then press
Enter
3. Highlight the option
Save & Exit Setup
, then press
Enter
.
4. Type
Y
to select Yes, then press
Enter
to save the changes in CMOS.
You must load the Setup default settings in the following instances:
−
When you replace the system battery
−
When you customize your system configuration settings and some resource assignments conflict causing the
computer to hang.
Set Administrator Password
Supervisor password controls the access to the setup utility.
Set Password
In this option, you can create a password to restrict access to the Setup Utility or to your System. You can also change or
remove the password.
If you set up a password for entering setup, you must type this password each time you want to enter the Setup utility. If you
do not type the correct password, you cannot enter Setup.
If you set up a system password, you must type this password each time you power on your system.
Exiting Setup (Save & Exit Setup/Exit Without Saving)
Press Esc to return to the main menu when you have finished viewing settings and making changes. From this location, you
can exit Setup and save your changes or exit without saving your changes.
Follow these steps to exit Setup:
1. From the main menu, press the
Esc
key.
2. The Exit Setup dialog box appears saying Quit Without Saving (Y/N)? Type
Y
if you want to quit directly.
You also can Exit the Setup via highlighting the
Save & Exit Setup
option or
Exit without Saving
option and follow the
dialog box directions.